Furnace tune up special and diagnostic $ 49.00
Included in the service call, complete diagnostics of heating and air conditioning system , plus an accurate estimate of repair cost.
Preventative maintenance is very important on your heating and air-conditioning system, routine maintenance will save you a lot of money on major part replacement as there are routine maintenance parts on all systems that can and will take out major components. We offer preventative maintenance contracts with two visits per year, we tear down the furnace once before winter and completely clean and maintenance all mechanical parts and check capacitors, motors, filters, wiring, control boards, hot surface igniter, flame sensor, pressure switches, limits, cracks in vacuum lines and drain lines and carbon monoxide testing on heat exchangers for cracks, test humidifiers/dehumidifiers check and test T-Stat's and wiring. Second visit spring time air-conditioning/heat pump: we clean outdoor coils check outdoor fan motor, capacitors, compressor, high-voltage contactor, low-voltage T-Stat side of contactor, defrost board on heat pumps, reversing valves, refrigerant levels.
Gold contract $ 139. 00 Per year: includes two maintenance visits per year on your heating and air-conditioning system, 20% off on all parts, filters, new heating and air-conditioning equipment replacement or any system add on's No service call fee during business hours, after hours $49. 00.
Platinum contract $ 199.00 per year: includes two maintenance visits per year on your heating and air-conditioning system, 20% off on all parts, filters, new heating and air-conditioning equipment replacement or any system add on's No service call fee.
Do you have rooms that are hotter or colder than others by an extreme amount of temperature? That is because a proper heat load calculation was not done for your home before your new system or duck work was installed or the heating and air-conditioning system and duct work was too small or too large for your home or improperly installed. Most companies do not employ a mechanical engineer and do their heat load calculations with a cardboard cutout and if your house fits within the hole of the cardboard cutout standing in the street, whatever's printed on the board is what they install size wise, we are an engineering company and do proper heat load calculations so that your heating and air-conditioning system will work as it was designed to work. When doing heat load calculations everything comes into effect windows, between wall insulation, ridge vent cap on the roof, doors, addict insulation, size of the rooms, height of the rooms, etc. etc. but you get the idea if not done right it does not work very efficiently and drives up your heating and cooling bills. This is just one of the things that we offer as an engineering heating and air conditioning company.